HP Start Up and Service Instructions

Before operating your HP25 or HP30 for the first time, ensure the following steps are completed:

• Verify all shipping brackets and restraints have been removed
• Position the unit on a level surface near appropriate power and drain connections
• Fill the solution tank with water to the indicated level before adding detergent
• Add the recommended aqueous cleaning detergent per manufacturer specifications
• Connect to the appropriate electrical supply (verify voltage rating on nameplate)

Follow these steps for standard operation:

• Ensure the solution level is at or above the minimum fill line
• Power on the unit and allow the heater to bring the solution to operating temperature (approximately 30–45 minutes for initial startup)
• Place parts on the removable work tray inside the cabinet
• Close the cabinet door securely
• Use the ergonomic spray wand to direct high-pressure solution onto the parts
• After cleaning, allow parts to drain before removing

Regular maintenance ensures optimal performance and longevity:

• Daily: Check solution level; top off as needed. Remove debris from the screened filter basket.
• Weekly: Inspect the spray wand nozzle for blockage. Clean the window-clearing blower intake.
• Monthly: Drain and clean the solution tank. Inspect the heater element for scale buildup. Check pump pressure output.
• As Needed: Replace solution when cleaning performance diminishes. Replace filter basket screens if damaged.

Common issues and solutions:

• Low pressure: Check solution level, inspect nozzle for blockage, verify pump operation
• Solution not heating: Check thermostat setting, verify heater element, check electrical connections
• Pump not running: Verify power connection, check low-water shutoff sensor, inspect pump for debris
• Poor cleaning results: Check solution concentration, verify temperature is at operating level, inspect nozzle spray pattern